Update the Autocom from 2011.1 version to 2011.3 version
Posted by eobdtool at December 13th, 2012
Hello! Let us help you to update the autocom from 2011.1 version to 2011.3 version.
Follow us to activate your Autocom CDP Pro CARS 2011 release 3.
1.TURN OFF your internet connection! ( for setup and activation only. after finish activation you can use internet )
2.Insert a USB-memory stick with at least 1MB free space!
3.SETUP software ( start.exe ) ,
4.Write product ID( for cars : a-710-479 ) , ( for trucks : a-710-254 )
5.Write the S/N and Hardware Key ( for Cars : serial number; 30250, HW key; MNZTTOOCNHVE )
( for Trucks : serial number; 39071, HW key; PUKRJOIVQTYX )
7. Click ON ” Activate via USB ”
8.Insert a USB-memory stick with at least 1MB free space
9. And you will have the ” FileActivation.xml ” file in USB-memory stick
10. Post this FileActivation.xml file to me [ firstname.lastname@example.org ] with REFERANCE NUMBER ( for referance number contact with sales )
Remarks : Please send an .xml file with referance number. I will not answer mail if haven’t referance number.
Then I will send you new a FileActivation.xml file, copy into USB-memory stick .
And connect to USB-memory stick to computer. Software will get infos in.
If not you can select to manual mode and open xml file
Eject to usb-memory
Software will open then will have an error ( Failed to load vehicle …… )
Run ” Update_3_-_2011_Release_3 ” , write product ID( for cars : a-710-479 ) , ( for trucks : a-710-254 )
Then next: sofware will open !
If you used alreday old verison autocom, for use interface you need make frimware update:
1.Connect interface to car .( for power )
2.Setting , hw test , it will have a message ask about frimware update . click to ok and it will make frimware update.
3.You need wait few minute for frimware update.( when is make frimware update ,don’t close software or don’t remove power ,etc )
Then you can use autocom 2011 release3